A27 Removable Hard Disk Drive Replacement for E5052A Serial Prefix
A27 Removable Hard Disk Drive Replacement for E5052A
Serial Prefix MY442 and above
Tools Required
•
TORX screwdriver T8, T10 and T15
Save Backup Files to the PC
When the removable hard disk drive is readable, you have to perform the following steps.
For details of the adjustment program, refer to Chapter 3 on page 73.
Step 1. Run the adjustment program.
Step 2. Input the GPIB address of the E5052A.
Step 3. Input the serial number of the E5052A.
Step 4. Perform the adjustment using "Backup" in Spot Adjustment of the program.
Removal Procedure
Refer to Figure 6-5 for this procedure.
Step 1. Remove the four TORX T15 screws (item 1) fastening the lid (item 2).
Step 2. Remove the four TORX T10 screws (item 3) fastening the HDD braket.
Step 3. Remove the two TORX T8 screws (item 4).
Step 4. Remove the four TORX T10 screws (item 5), and remove the HDD bracket.
Step 5. Remove the hard disk drive from the connector board.
Chapter 6
Replacement Procedure
MY442 and above
183