Aisys
6.12.6 Right-side cable route
To access the cable route on the right side of the machine,
remove the lower and upper right-side cosmetic panels.
T
Route the cables through the cable clamps shown
(
).
arrows
Note: When replacing the lower cosmetic panel, position
the cables within the beveled edge of the extrusion to
allow a flush mount of the panel without pinching the
cables
Cable from the upper chassis can be routed in this area
through the cutout (
) in the chassis.
T
Additional cables can be routed into this area through the
upper cosmetic panel. First, remove the plug (
); then,
U
route the cable through the upper panel. Flip the plug over
before replacing it onto the cosmetic panel.
U
6-24
04/08 M1046983