Display Unit And Anesthesia Monitor; Display Arm - GE Datex-Ohmeda Aisys Carestation Reference Manual

6.11.1 Display Unit and Anesthesia Monitor

Attach the respective cables to the Display Unit (
and, if present, to the monitor (
Leave enough cable length outside the arm to allow
positioning of the displays throughout the full range
without straining the cables.
Use cable ties to keep the monitor cable attached
neatly behind the assembly.
Ensure that each cable has a slight loop (
wrist casting ( ).
D

6.11.2 Display arm

Route the cables through the Display Arm retaining
clips ( ) and the wrist casting as shown.
E
To ensure adequate cable length for the full range of
arm and display motion:
1. Move the arm down to a horizontal position.
Arrange the cables so that they fall within the
shaded area on the label.
2. Swing the arm to its extreme counterclockwise
position and place the display up against the arm.
3. Replace the base cover with adhered gasket (
hold the cables in place.
M1046983 04/08
)
A
).
B
) at the
C
) to
F
F
6 Installation and Maintenance
B
A
D
C
E
E
6-17