Table of Contents
Advertisement
TruSat Technical Reference Manual
Left side assembly
Right side assembly
4–14
9.
Install the power button pad at S1 on the Display board by inserting the two guide
"posts" through the matching holes on the Display board.
10. Slide the boards all the way into the housing, taking care not to dislodge the Alarm
Silence button, the power button, and the power button pad.
1.
Position the SpO
code ring inside the left bumper and cover it with the left inner end
2
plate.
2.
Position the bumper and end plate over the left side of the housing, fitting it over the
SpO
connector and RS-232 connector, as applicable.
2
3.
Place the outer end plate over the bumper and install the 3 screws that secure the
left bumper assembly to the housing.
1.
Position the speaker over the two posts inside the right bumper with the speaker
cable near the center of the bumper.
2.
Slip the spacer over the ComWheel encoder post and insert the encoder post
through the hole in the right inner end plate. Be sure the end plate standoffs and the
encoder post face away from the housing.
3.
Orient the encoder with its cable toward the center of the end plate and install the
washer and nut that secure the encoder to the end plate. Install the ComWheel
encoder nut, using a 7/16 inch nut driver.
4.
Position the right inner end plate in the right bumper, routing the speaker cable
through the large hole in the inner end plate. On the outside of the bumper, align the
ComWheel over the flat side of the encoder post, then press gently until the
ComWheel slides into place.
5.
Connect the speaker cable and the ComWheel encoder cable to the System board.
Position the cables inside the housing to ensure they will not be pinched.
6.
Place the right bumper over the housing. Place the outer end plate over the bumper
and install the 3 screws that secure the bumper assembly to the housing.
Important: Test the monitor. See Functional check earlier in this chapter.
Hide quick links:
Advertisement
Table of Contents
