Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual page 150

Hard disk drive (HDD) / solid state disk (SSD)
▶ Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page
CAUTION
The HDD/SSD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD/SSD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
Removing the right side 4x 2.5-inch HDD backplane
Figure 81: Disconnecting the cables (NVMe variant)
▶ Disconnect all cables from the HDD backplane.
150 Upgrade and Maintenance Manual
142.
139.
RX1330 M5