Disconnecting The Power Cord" On Page; Getting Access To The Component" On Page; Removing The Air Duct" On Page - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

CAUTION
▶
Before replacing the system board, ask the customer whether TPM
functionality is used.
▶
If the customer is using TPM functionality, remove the TPM from
the old system board and install it on the new system board.
▶
Advise your contact persons that they must provide you with all
recovery keys which belong to the system to restore them in the
TPM later.
Note on system information backup/restore
The COP contains the Chassis ID EPROM that contains system information
like server name and model, housing type, serial number and manufacturing
data. To avoid the loss of non-default settings when replacing the system
board, a backup copy of important system configuration data is automatically
stored from the system board NVRAM to the Chassis ID EPROM.
CAUTION
For that reason the COP and the system board must not be replaced
simultaneously! In this case, restoring the system configuration data on
the system board would fail.
After replacing the system board the backup data is restored from the Chassis
ID EPROM to the new system board.
Preliminary steps
▶
"Locating the defective server" on page
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶

"Disconnecting the power cord" on page

▶ Disconnect all external cables.
▶ Remove all PSUs, see
▶

"Getting access to the component" on page

▶

"Removing the air duct" on page

RX1330 M5
46.
"Removing a hot-plug PSU" on page
65.
Upgrade and Maintenance Manual
System board and components
43.
69.
47.
49.
45.
105.
329