Tools:
Phillips PH1 / (+) No. 1 screw driver
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Removing the air duct" on page
Removing the defective front USB
▶ Disconnect the front USB cable from the system board connector "TYPE C
FRONT".
Figure 226: Removing the front USB connector
▶ Remove the two screws (see circles).
▶ Pull the front USB connector out of the recess at the front panel.
▶ Remove the front USB cable.
RX1330 M5
46.
65.
Upgrade and Maintenance Manual
47.
49.
Front panel
45.
279