Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual page 153

1 NVMe cable to connector "C2/C3" on the first RAID controller in riser
module 1
2 NVMe cable to connector "C0/C1" on the first RAID controller in riser
module 1
Figure 86: Connecting the cables (SAS/SATA variant)
▶ Connect the following cables to the HDD backplane:
1 SAS cable
2 OOB cable
3 Power cable
For the cable plan, see
Concluding steps
▶ Insert all HDD/SSD modules, see
on page 140.
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
▶ Insert all dummy modules, see
page 143.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
RX1330 M5
Hard disk drive (HDD) / solid state disk (SSD)
"Appendix B" on page
"Installing a 2.5-inch HDD/SSD module"
"Installing a 2.5-inch dummy module" on
53.
57.
60.
Upgrade and Maintenance Manual
363.
153