▶ Connect the following cables to the SAS expander board:
1 SAS cable, leading to connector "C0" on the RAID controller
2 SAS cable, leading to connector "C1" on the RAID controller
Figure 104: Connecting the power cable
▶ Connect the power cable to the HDD backplane.
For the cable plan, see
Concluding steps
▶ Insert all HDD/SSD modules, see
on page
140.
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
▶ Insert all dummy modules, see
page
143.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
RX1330 M5
Hard disk drive (HDD) / solid state disk (SSD)
"Appendix B" on page
"Installing a 2.5-inch HDD/SSD module"
"Installing a 2.5-inch dummy module" on
53.
57.
60.
Upgrade and Maintenance Manual
363.
61.
163