Replacing The Front Vga In The Front Vga Module - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

13.4.3

Replacing the front VGA in the front VGA module

Upgrade and Repair Unit
(URU)
Tools:
hexagon screw driver 5 mm
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Removing the air duct" on page
Removing the defective front VGA
▶ Disconnect the front VGA cable from the system board connector "Front
VGA".
▶ Remove the front VGA module, see
page 265.
Figure 215: Removing the front VGA connector
RX1330 M5
46.
65.
"Removing the front VGA module" on
A
Upgrade and Maintenance Manual
Hardware: 5 minutes
47.
49.
Front panel
45.
269