Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual page 146

Hard disk drive (HDD) / solid state disk (SSD)
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Connecting the power cord" on page
▶
"Getting access to the component" on page
▶ Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page
CAUTION
The HDD/SSD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD/SSD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page
Removing the left side 4x 2.5-inch HDD backplane
Figure 75: Releasing the ODD
▶ If applicable, disconnect the ODD cables (1).
▶ If applicable, press the ODD latch downward (2) until it disengages and
push the ODD somewhat in direction of the front side (3).
146
46.
57.
Upgrade and Maintenance Manual
43.
49.
142.
142.
45.
RX1330 M5