Switching Off The Id Indicator - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

After replacing or upgrading LAN controllers
You need to restore the configuration for the LAN Teaming, using the LAN
driver utility or OS teaming software.
▶ Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
For more information, see the relevant LAN driver manual.
After replacing a system board
The following procedure must be done for each system board that is
replaced.
▶ Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
▶ If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility or OS teaming software.
For more information, see the relevant LAN driver manual.
5.3.16

Switching off the ID indicator

▶ Press the ID button on the front panel, or use the iRMC S6 web interface or
the Infrastructure Manager to switch off the ID indicator after the
maintenance task has been concluded successfully.
For more information, see
the "ServerView Suite Local Service Concept (LSC)", the iRMC user
guides or the Infrastructure Manager documentation.
Using the ID button on the front panel
▶ Press the ID button on the front panel to switch off the ID indicators.
RX1330 M5
"Locating the defective server" on page 43
Upgrade and Maintenance Manual
Basic software procedures
or
93