Table of Contents
Advertisement
9.4.4
Open a measuring mode
The desired measuring mode is selected in the Device control menu. The following measuring modes are available:
•
Linescan see chapter 9.7 „Linescan" on page 48
•
Single planes see chapter 9.8 „Single planes" on page 51
•
Monitor see chapter 9.9 „Monitor" on page 56
•
Manual caustic see chapter 9.10 „Manual Caustic" on page 59
•
Automatic caustic see chapter 9.11 „Automatic Caustic" on page 61
X
After opening the Device control menu,
click the button of the desired measuring
mode, for example Single planes.
A drop-down list for changing the
measuring mode appears in the upper
area of the Device control menu.
Change measuring mode:
1.
Click on the button to open the drop-
down list.
2.
Select measuring mode.
After selecting the measuring mode, the
corresponding toolbench is opened.
If the toolbench has been closed, re-open
it by clicking the Open measurement
toolbench button.
34
FocusMonitor FM+
Revision 08 EN - 08/2023
Advertisement
Table of Contents
