Aaa Setup - ZyXEL Communications XS3800-28 User Manual

Table 292 SECURITY > AAA > TACACS+ Server Setup (continued)
LABEL
Shared Secret
Encrypted
Shared Secret
Accounting Server
Use this section to configure your TACACS+ accounting settings.
Timeout
Delete
Index
IP Address
TCP Port
Shared Secret
Encrypted
Shared Secret
Apply
Cancel

74.4 AAA Setup

Use this screen to configure authentication, authorization and accounting settings on the Switch. Click
SECURITY > AAA > AAA Setup to view the screen as shown.
Chapter 74 AAA
DESCRIPTION
Specify a password (up to 32 alphanumeric characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) as the
key to be shared between the external TACACS+ server and the Switch. This key is not sent over
the network. This key must be the same on the external TACACS+ server and the Switch.
This displays the encrypted shared secret in '*' format if you enabled Server Key Encryption in
SECURITY > AAA > AAA Setup.
Note: If you forget the key you set, simply reset the key in the Shared Secret field. If a
key is encrypted, it will remain in the encrypted format even if you later
disable Server Key Encryption in SECURITY > AAA > AAA Setup.
Note: The shared secret displayed in this field does not present the actual length of
the shared secret.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the TACACS+ server.
Check this box if you want to remove an existing TACACS+ accounting server entry from the
Switch. This entry is deleted when you click Apply.
This is a read-only number representing a TACACS+ accounting server entry.
Enter the IP address of an external TACACS+ accounting server in dotted decimal notation.
The default port of a TACACS+ accounting server is 49. You need not change this value unless
your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) as the
key to be shared between the external TACACS+ accounting server and the Switch. This key is
not sent over the network. This key must be the same on the external TACACS+ accounting
server and the Switch.
This displays the encrypted shared secret in '*' format if you enabled Server Key Encryption in
SECURITY > AAA > AAA Setup.
Note: If you forget the key you set, simply reset the key in the Shared Secret field. If a
key is encrypted, it will remain in the encrypted format even if you later
disable Server Key Encryption in SECURITY > AAA > AAA Setup.
Note: The shared secret displayed in this field does not present the actual length of
the shared secret.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS3800-28 User's Guide
547