Add/Edit Ip Interfaces - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Table 47 SYSTEM > IP Setup > IP Setup (continued)

IP Interface

Use this section to view and configure IP routing domains on the Switch.

IP Subnet Mask

23.3.1 Add/Edit IP Interfaces

Use this screen to add or edit IP interfaces. Click Add/Edit, or select an entry and click Add/Edit in the

SYSTEM > IP Setup > IP Setup screen to display this screen.

Figure 104 SYSTEM > IP Setup > IP Setup > Add/Edit

Chapter 23 IP Setup

Enter the IP subnet mask of your Switch in dotted decimal notation, for example, 255.255.255.0.

Enter the IP address of the default outgoing gateway in dotted decimal notation, for example,

192.168.0.254.

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to save

your changes to the non-volatile memory when you are done configuring.

Click Cancel to reset the fields to your previous configuration.

This field displays the index number of an entry.

This field displays the IP address of the Switch in the IP domain.

This field displays the subnet mask of the Switch in the IP domain.

This field displays the VLAN identification number of the IP domain on the Switch.

This field displays the type of IP address status. Static or DHCP.

Select an entry's check box to select a specific entry. Otherwise, select the check box in the

table heading row to select all entries.

Click Add/Edit to add a new IP interface or edit a selected one.

Click Delete to remove the selected IP interfaces.

XS3800-28 User's Guide