Add Igmp Filtering Profile; Add Igmp Filtering Rule - ZyXEL Communications XS3800-28 User Manual

Table 137 SWITCHING > Multicast > IPv4 Multicast > IGMP Filtering Profile (continued)
LABEL
Add Rule
Delete

44.5.1 Add IGMP Filtering Profile

To access this screen, click the Add Profile button in the SWITCHING > Multicast > IPv4 Multicast > IGMP
Filtering Profile screen.
Figure 227 SWITCHING > Multicast > IPv4 Multicast > IGMP Filtering Profile > Add Profile
The following table describes the labels in this screen.
Table 138 SWITCHING > Multicast > IPv4 Multicast > IGMP Filtering Profile > Add Profile
LABEL
Profile Name
Start Address
End Address
Apply
Clear
Cancel

44.5.2 Add IGMP Filtering Rule

Click Add Rule in the SWITCHING > Multicast > IPv4 Multicast > IGMP Filtering Profile screen to access this
screen.
Chapter 44 Multicast
DESCRIPTION
Click Add Rule to add a new rule and specify the profile it belongs to in the Add Rule screen.
You can also select a profile entry and click Add Rule to add an additional rule for the
selected profile.
Select a profile and click Delete to remove the selected profile and the accompanying rules.
Select a rule from a profile and click Delete to remove the selected rule.
DESCRIPTION
Enter a descriptive name for the profile for identification purposes. You can enter up to 32
printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile. If you want to add a single multicast IP address, enter it in both the Start
Address and End Address fields.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XS3800-28 User's Guide
316