ZyXEL Communications XS3800-28 User Manual page 515

Table 274 NETWORKING > OSPF > IPv4 OSPF > OSPF Virtual-Link > Add/Edit (continued)
LABEL DESCRIPTION
Key ID When you select MD5 in the Authentication field, specify the identification number of the
authentication you want to use.
Key When you select Simple in the Authentication field, enter a password eight-character long.
When you select MD5 in the Authentication field, enter a password 16-character long.
Retransmit Specify how long (in seconds) the Switch should wait for an acknowledgment packet from the
Interval interface's neighbor device before retransmitting link-state advertisements (LSAs) on the
interface. The valid range for retransmitting is between 1 and 65535. The default value is 5
seconds.
Transmit Delay Set the estimated time (in seconds) that is required to transmit a link-state update packet on
the interface. The valid range for transmitting delay is between 1 and 65535. The default value
is 1 second.
Hello Interval Specify how often (in seconds) the Switch sends hello packets on the interface to check if the
interface's neighbor devices still exist. The valid range for hello interval is between 1 and 65535.
The default value is 10 seconds.
Dead Interval Specify how long (in seconds) the Switch should wait for a hello packet from the interface's
neighbor device before declaring that the neighbor device is not available. The valid range for
dead interval is between 1 and 65535. The default value is 40 seconds.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Chapter 67 OSPF
XS3800-28 User's Guide
515