Add/Edit Ipv4 Ospf Redistribution - ZyXEL Communications XS3800-28 User Manual

The following table describes the labels in this screen.
Table 271 NETWORKING > OSPF > IPv4 OSPF > OSPF Redistribution
LABEL
Redistribute
Route
Active
Type
Metric Value
Apply
Cancel
Index
Summary
Address
Subnet Mask
Add/Edit
Delete

67.5.1 Add/Edit IPv4 OSPF Redistribution

Use this screen to configure the summary address settings.
Click Add/Edit, or select an entry and click Add/Edit in the NETWORKING > OSPF > IPv4 OSPF > OSPF
Redistribution to display this screen.
Figure 406 NETWORKING > OSPF > IPv4 OSPF > OSPF Redistribution > Add/Edit
Chapter 67 OSPF
DESCRIPTION
Route redistribution allows your Switch to import and translate the following external routes into
the OSPF network transparently:
• routes learned through RIP routing protocol, or
• Static routes that are configured manually, or
• Connected routes to the interfaces that are directly connected to the Switch interfaces.
These interfaces must have an IP address, such as a loopback interface, DHCP interface, or
VLAN interface.
The Switch will send out the external routes information to other routers in the OSPF network
through LSAs.
Enable the switch button to activate route redistribution for routes learned through the selected
protocol.
Select 1 for routing protocols (such as RIP) whose external metrics are directly comparable to
the internal OSPF cost. When selecting a path, the internal OSPF cost is added to the AB
boundary router to the external metrics.
Select 2 for routing protocols whose external metrics are not comparable to the OSPF cost. In this
case, the external cost of the AB boundary router is used in path decision to a destination.
Enter a route cost (between 0 and 16777215). The default metric value is 15.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the index number of the summary address.
This field displays the summary IP address.
This field displays the subnet mask for the summary IP address.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
XS3800-28 User's Guide
512