Ipv4 Static Route; Add/Edit Ipv4 Static Route - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

71.2 IPv4 Static Route

Click NETWORKING > Static Routing > IPv4 Static Route to display the screen as shown.

Note: You can create more than one static route link with the same destination. Only one

valid route link with the lowest metric will be set as the primary active link. If both links

are reachable and the metrics are the same, the Switch will choose the one that has a

lower IP address to be the primary link.

Note: If you enable Route Failover in the NETWORKING > Router Setup screen, a valid

secondary link will be automatically set to active when the primary link goes DOWN.

Figure 416 NETWORKING > Static Routing > IPv4 Static Route

The following table describes the related labels you use to create a static route.

Table 282 NETWORKING > Static Routing > IPv4 Static Route

Click Add/Edit, or select an entry and click Add/Edit in the NETWORKING > Static Routing > IPv4 Static

Route screen to display this screen.

Chapter 71 Static Route

This field displays the index number of the route.

This field displays whether the static route is activated or not.

This field displays the descriptive name for this route. This is for identification purposes only.

This field displays the IP network address of the final destination.

This field displays the subnet mask for this destination.

This field displays the IP address of the gateway. The gateway is an immediate neighbor of your

Switch that will forward the packet to the destination.

This field displays the cost of transmission for routing purposes.

Select an entry's check box to select a specific entry. Otherwise, select the check box in the

table heading row to select all entries.

Click Add/Edit to add a new entry or edit a selected one.

Click Delete to remove the selected entries.

XS3800-28 User's Guide