Mac Forwarding - ZyXEL Communications XS3800-28 User Manual
28-port 10gbe l3 managed switch
Hide thumbs
Also See for XS3800-28:
- User manual (719 pages) ,
- Cli reference manual (407 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Table 156 SWITCHING > NLB > IP Configuration> Add/Edit (continued)
LABEL
MAC Address
Apply
Clear
Cancel
46.3 MAC Forwarding
Use this screen to view and configure to which MAC addresses and ports the Switch should forward the
incoming NLB traffic.
Click SWITCHING > NLB > MAC Forwarding to display the screen as shown.
Note: The following screens cannot have duplicate settings as the SWITCHING > NLB > MAC
Forwarding screen.
• SWITCHING > Static MAC Forwarding
• SWITCHING > Multicast > Static Multicast Forwarding By MAC
• SWITCHING > Static MAC Filtering
Figure 255 SWITCHING > NLB > MAC Forwarding
The following table describes the labels in this screen.
Table 157 SWITCHING > NLB > MAC Forwarding
LABEL
Index
Name
MAC Address
VID
Port
Chapter 46 NLB
DESCRIPTION
Enter a multicast or unicast MAC address added in the SWITCHING > NLB > MAC Forwarding
screen.
The last binary bit of the first octet pair in a multicast MAC address must be 1. For example, the
first octet pair 00000001 is 01 and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A and
03:00:5e:00:00:27 are valid multicast MAC addresses.
The last binary bit of the first octet pair in a unicast MAC address must be 0. For example, the
first octet pair 00000000 is 00 and 00000010 is 02 in hexadecimal, so 00:00:5e:00:00:0A and
02:00:5e:00:00:27 are valid unicast MAC addresses.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
DESCRIPTION
This field displays the index number of the rule.
This field displays the descriptive name of the rule.
This field displays the multicast or unicast MAC address of this rule.
This field displays the VLAN group identification number.
This field displays the ports to which the Switch will forward the incoming NLB traffic.
In Stacking mode, the first number represents the slot ID and the second is the port number.
XS3800-28 User's Guide
341
Advertisement
Table of Contents
Troubleshooting
