Ipv6 Multicast Status - ZyXEL Communications XS3800-28 User Manual

Figure 228 SWITCHING > Multicast > IPv4 Multicast > IGMP Filtering Profile > Add Rule
The following table describes the labels in this screen.
Table 139 SWITCHING > Multicast > IPv4 Multicast > IGMP Filtering Profile > Add Rule
LABEL
Profile Name
Start Address
End Address
Apply
Clear
Cancel

44.6 IPv6 Multicast Status

Click SWITCHING > Multicast > IPv6 Multicast > IPv6 Multicast Status to display the screen as shown. This
screen shows the IPv6 multicast group information. See
on multicasting.
Figure 229 SWITCHING > Multicast > IPv6 Multicast > IPv6 Multicast Status
The following table describes the fields in the above screen.
Table 140 SWITCHING > Multicast > IPv6 Multicast > IPv6 Multicast Status
LABEL
Index
VID
Chapter 44 Multicast
DESCRIPTION
Select a profile from the drop-down list to add a additional rule for the existing profile.
Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile. If you want to add a single multicast IP address, enter it in both the Start
Address and End Address fields.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
DESCRIPTION
This is the index number of the entry.
This field displays the multicast VLAN ID.
XS3800-28 User's Guide
317
Section 44.1 on page 304 for more information