Firmware Upgrade; Reboot System - ZyXEL Communications XS3800-28 User Manual

88.44 Firmware Upgrade

Use the following screen to upgrade your Switch to the latest firmware.
Note: Make sure you have downloaded (and unzipped) the correct model firmware and
version to your computer before uploading to the device.
Click MAINTENANCE > Firmware Upgrade to view the screen as shown next.
Figure 596 MAINTENANCE > Firmware Upgrade
Click Choose File or Browse to locate the firmware file you wish to upload to the Switch. Firmware
upgrades are only applied after a reboot. Click Upgrade to load the new firmware.
After the firmware upgrade process is complete, see the MONITOR > System Information screen to verify
your current firmware version number.
Table 405 MAINTENANCE > Firmware Upgrade
LABEL
Name
Version
File Path
Upgrade

88.45 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load the Current Configuration, a Custom Default or the Factory Default configuration when you
reboot. Follow the steps below to reboot the Switch.
Click MAINTENANCE > Reboot System to view the screen as shown next.
Chapter 88 Networked AV Mode
DESCRIPTION
This is the name of the Switch that you are configuring.
This is the version number (and model code) and MM/DD/YYYY creation date of the
firmware currently in use on the Switch. The firmware information is also displayed in
MONITOR > SYSTEM Information.
Click Choose File or Browse to locate the firmware file you wish to upload to the Switch.
Click Upgrade to load the new firmware. Firmware upgrades are only applied after a
reboot. To reboot, go to MAINTENANCE > Reboot System and click Current Configuration,
Factory Default, or Custom Default (Current Configuration, Factory Default, and Custom
Default are the configuration files you want the Switch to use when it restarts).
XS3800-28 User's Guide
744