Classifier Example - ZyXEL Communications XS3800-28 User Manual

Table 308 SECURITY > ACL > Classifier > Classifier Global Setting (continued)
LABEL
Active
Interval
Apply
Cancel

76.5 Classifier Example

The following screen shows an example where you configure a classifier that identifies all traffic from
MAC address 00:50:ba:ad:4f:81 on port 2.
Chapter 76 Classifier
DESCRIPTION
Enable the switch button to allow the Switch to create a log when packets match a classifier rule
during a defined time interval.
Set the length of the time period (in seconds) to count matched packets for a classifier rule. Enter an
integer from 0 – 65535. 0 means that no logging is done.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS3800-28 User's Guide
574