ZyXEL Communications XS3800-28 User Manual page 448

Figure 345 SWITCHING > VLAN Mapping > VLAN Mapping Setup > Add/Edit (Stacking Mode)
The following table describes the labels in this screen.
Table 221 SWITCHING > VLAN Mapping > VLAN Mapping Setup > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to activate this rule.
Name Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ])
for identification purposes.
Port Type a port to be included in this rule. In Stacking mode, the first field is the slot ID and the
second field is the port number.
VID Enter a VLAN ID from 1 to 4094. This is the VLAN tag carried in the packets and will be translated
into the VID you specified in the Translated VID field.
Translated VID Enter a VLAN ID (from 1 to 4094) into which the customer VID carried in the packets will be
translated.
Priority Select a priority level (from 0 to 7). This is the priority level that replaces the customer priority
level in the tagged packets or adds to the untagged packets.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Chapter 59 VLAN Mapping
XS3800-28 User's Guide
448