ZyXEL Communications XS3800-28 User Manual page 284

Table 121 SWITCHING > Layer 2 Protocol Tunneling (continued)
LABEL DESCRIPTION
Mode Select Access to have the Switch encapsulate the incoming layer 2 protocol packets and
forward them to the tunnel ports. Select Access for ingress ports at the edge of the service
provider's network.
Note: You can enable L2PT services for STP, LACP, VTP, CDP, UDLD, PAgP, and LLDP on
the access ports only.
Select Tunnel for egress ports at the edge of the service provider's network. The Switch
decapsulates the encapsulated layer 2 protocol packets received on a tunnel port by
changing the destination MAC address to the original one, and then forward them to an access
port. If the services is not enabled on an access port, the protocol packets are dropped.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Chapter 40 Layer 2 Protocol Tunneling
XS3800-28 User's Guide
284