Table 132 SWITCHING > Mirroring > RMirror > Connected Port > Add/Edit (continued)
LABEL
DESCRIPTION
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Connected Port
When the Switch is a source device in remote port mirroring, select this option to have the
port help forward mirrored traffic to the connected port of the intermediate or destination
device in the same RMirror VLAN.
When the Switch is an intermediate device in remote port mirroring, select this option to
have the port receive mirrored traffic from the connected source or another intermediate
device or forward mirrored traffic to the connected destination or another intermediate
device in the same RMirror VLAN.
When the Switch is a destination device in remote port mirroring, select this option to have
the port receive mirrored traffic from the connected source or intermediate device in the
same RMirror VLAN.
Apply
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click Clear to clear the fields to the factory defaults.
Cancel
Click Cancel to not save the configuration you make and return to the last screen.
Chapter 43 Mirroring
XS3800-28 User's Guide
303