Error-Disable Detect Setup - ZyXEL Communications XS3800-28 User Manual

The following table describes the labels in this screen.
Table 320 SECURITY > Errdisable > CPU Protection
LABEL
Reason
SLOT
Port
*
Rate Limit (pkt/s) Enter a number from 0 to 256 to specify how many control packets this port can receive or
Apply
Cancel

81.4 Error-Disable Detect Setup

Use this screen to have the Switch detect whether the control packets exceed the rate limit configured
for a port and configure the action to take once the limit is exceeded. Click SECURITY > Errdisable >
Errdisable Detect to display the screen as shown.
Figure 474 SECURITY > Errdisable > Errdisable Detect
Chapter 81 Error-Disable
DESCRIPTION
Select the type of control packet you want to configure here.
This field appears only in Stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
This field displays the port number. In Stacking mode, the first number represents the slot ID and
the second is the port number. Please note that the default stacking ports (the last four ports of
your Switch) cannot be configured. They are reserved for stacking only.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
transmit per second.
0 means no rate limit.
You can configure the action that the Switch takes when the limit is exceeded.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS3800-28 User's Guide
601