Add/Edit Ip Interfaces; Logins - ZyXEL Communications XS3800-28 User Manual

88.11.1 Add/Edit IP Interfaces

Use this screen to add or edit IP interfaces. Click Add/Edit, or select an entry and click Add/Edit in the
SYSTEM > IP Setup screen to display this screen.
Figure 560 SYSTEM > IP Setup > Add/Edit
The following table describes the labels in this screen.
Table 375 SYSTEM > IP Setup > Add/Edit
LABEL
DHCP Client
Static IP Address
IP Address
IP Subnet
Mask
VID
Apply
Clear
Cancel

88.12 Logins

Up to five people (one administrator and four non-administrators) may access the Switch through Web
Configurator at any one time.
• An administrator is someone who can both view and configure Switch changes. The user name for
the Administrator is always admin. The default administrator password is 1234.
Note: It is highly recommended that you change the default administrator password (1234).
• A non-administrator (user name is something other than admin) is someone who can view and/or
configure Switch settings. The configuration right varies depending on the user's privilege level.
Chapter 88 Networked AV Mode
DESCRIPTION
Select this option if you have a DHCP server that can assign the Switch an IP address, subnet
mask, a default gateway IP address and a domain name server IP address automatically.
Select this option if you do not have a DHCP server or if you wish to assign static IP address
information to the Switch. You need to fill in the following fields when you select this option.
Enter the IP address of your Switch in dotted decimal notation, for example, 192.168.1.1. This is
the IP address of the Switch in an IP routing domain.
Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
255.255.255.0.
Enter the VLAN identification number to which an IP routing domain belongs.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XS3800-28 User's Guide
702