ZyXEL Communications XS3800-28 User Manual page 701

Note: The Switch allows you to set a static IP interface in the same subnet that already has a
DHCP-assigned IP interface on the Switch. The Switch will use the static IP you set and
the DHCP-assigned IP will be set to 0.0.0.0.
Figure 559 SYSTEM > IP Setup
The following table describes the labels in this screen.
Table 374 SYSTEM > IP Setup
LABEL DESCRIPTION
IP Setup
Default Type the IP address of the default outgoing gateway in dotted decimal notation, for example
Gateway 192.168.1.254.
Domain Name Enter a domain name server IPv4 address in order to be able to use a domain name instead of
Server 1/2 an IP address.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
IP Interface
Use this section to view and configure IP routing domains on the Switch.
Index This field displays the index number of an entry.
IP Address This field displays the IP address of the Switch in the IP domain.
IP Subnet Mask This field displays the subnet mask of the Switch in the IP domain.
VID This field displays the VLAN identification number of the IP domain on the Switch.
Type This field displays the type of IP address status. Static or DHCP.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new IP interface or edit a selected one.
Delete Click Delete to remove the selected IP interfaces.
Chapter 88 Networked AV Mode
XS3800-28 User's Guide
701