Switching; Port Mirroring - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Table 386 PORT > Port Setup (continued)

88.23 SWITCHING

The following sections introduce the SWITCHING screens.

Port mirroring allows you to copy a traffic flow to a monitor port (the port you copy the traffic to) in order

that you can examine the traffic from the monitor port without interference.

Click SWITCHING > Mirroring in the navigation panel to display the Mirroring screen. Use this screen to

select a monitor port and specify the traffic flow to be copied to the monitor port.

Chapter 88 Networked AV Mode

Configure the way to treat BPDUs received on this port. You must activate Bridging Control

Protocol Transparency in the SYSTEM > Switch Setup screen first.

Select Peer to process any BPDU (Bridge Protocol Data Units) received on this port.

Select Tunnel to forward BPDUs received on this port.

Select Discard to drop any BPDU received on this port.

Select Network to process a BPDU with no VLAN tag and forward a tagged BPDU.

You can insert either an SFP+ transceiver or an SFP+ Direct Attach Copper (DAC) cable into the

10 Gigabit interface of the Switch.

Select the media type (SFP+ or DAC10G) of the SFP+ module that is attached to the 10 Gigabit

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to save

your changes to the non-volatile memory when you are done configuring.

Click Cancel to begin configuring this screen afresh.

XS3800-28 User's Guide