Add/Edit Flex Link - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Table 92 PORT > Flex Link > Flex Link Setup (continued)

Preemption Delay

32.3.1 Add/Edit Flex Link

To access this screen, click the Add/Edit button or select an entry from the list and click the Add/Edit

Note: A port can only be in one flex link pair. If a port has already been set as a flex link pair's

primary/backup port, the port can not be used by other flex links. Check the PORT >

Flex Link > Flex Link Setup screen to see what ports are already in other flex link pairs.

Figure 147 PORT > Flex Link > Flex Link Setup > Add/Edit (Standalone Mode)

Figure 148 PORT > Flex Link > Flex Link Setup > Add/Edit (Stacking Mode)

Chapter 32 Flex Link

This displays if Preemption is enabled on the flex link pair. If Preemption is enabled, when the

primary port comes back up, the backup port will go into BLOCKING state and the primary

port will go into FORWARDING state after the Preemption Delay Time interval.

This displays the preemption delay time configured for this flex link pair.

Select an entry's check box to select a specific entry. Otherwise, select the check box in the

table heading row to select all entries.

Click Add/Edit to add a new entry or edit a selected one.

Click Delete to remove the selected entry.

XS3800-28 User's Guide