Add Mld Snooping-Proxy Filtering Rule; General Mvr Configuration - ZyXEL Communications XS3800-28 User Manual

Table 147 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Profile (continued)
LABEL
End Address
Apply
Clear
Cancel

44.11.2 Add MLD Snooping-proxy Filtering Rule

Use this screen to create a multicast addresses range rule of the MLD filtering profile.
Click Add Rule in the SWITCHING > Multicast > IPv6 Multicast > Filtering Profile to display this screen.
Figure 239 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
The following table describes the fields in the above screen.
Table 148 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
LABEL
Profile Name
Start Address
End Address
Apply
Clear
Cancel

44.12 General MVR Configuration

Use this screen to view and create multicast VLANs.
Chapter 44 Multicast
DESCRIPTION
Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and End
Address fields.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
DESCRIPTION
Select a profile from the drop-down list to add a additional rule for the existing profile.
Type the starting multicast IPv6 address for a range of multicast IPv6 addresses that you want
to belong to the MLD filtering profile.
Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and End
Address fields.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XS3800-28 User's Guide
327