Custom Default; Firmware Upgrade - ZyXEL Communications XS1930-12HP User Manual

Figure 204 Load Factory Default: Confirmation
If you want to access the Switch web configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1 or DHCP-
assigned IP).

35.5.2 Custom Default

Follow the steps below to reset the Switch back to the Custom Default configuration file you created.
This will save the custom default configuration settings to both Configuration 1 and Configuration 2.
Click the Custom Default button.
1
Click OK to continue or Cancel to abort.
2
Note: If you did not save a custom default file in the web configurator, then the factory
default file is restored after you press click Custom Default (next to Reboot System) on
the Switch. You will then have to make all your configurations again on the Switch.
Figure 205 Load Custom Default: Confirmation

35.6 Firmware Upgrade

The Switch supports dual firmware images, Firmware 1 and Firmware 2. Use this screen to specify which
image is updated when firmware is uploaded using the web configurator and to specify which image is
loaded when the Switch starts up.
Make sure you have downloaded (and unzipped) the correct model firmware and version to your
computer before uploading to the device.
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.
Chapter 35 Maintenance
XS1930 Series User's Guide
284