Classifier Example - ZyXEL Communications XMG1930 Series User Manual

Figure 137 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
The following table describes the labels in this screen.
Table 91 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
LABEL
Match
Order
Logging
Active
Interval
Apply
Cancel

21.5 Classifier Example

The following screen shows an example where you configure a classifier that identifies all traffic from
MAC address 00:50:ba:ad:4f:81 on port 2.
Chapter 21 Classifier
DESCRIPTION
Select manual to have classifier rules applied according to the weight of each rule you configured in
Advanced Application > Classifier > Classifier Configuration.
Alternatively, select auto to have classifier rules applied according to the layer of the item configured
in the rule. Layer-4 items have the highest priority, and layer-2 items has the lowest priority. For
example, you configure a layer-2 item (VLAN ID) in classifier A and configure a layer-3 item (source IP
address) in classifier B. When an incoming packet matches both classifier rules, classifier B has priority
over classifier A.
Select this to allow the Switch to create a log when packets match a classifier rule during a defined
time interval.
Select the length of the time period (in seconds) to count matched packets for a classifier rule. Enter
an integer from 0 – 65535. 0 means that no logging is done.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
196