Add/Edit Interfaces - ZyXEL Communications GS1920v2 Series User Manual

20.2.1 Add/Edit Interfaces

Click Add/Edit, or select an entry and click Add/Edit in the SYSTEM > Interface Setup screen to display
the configuration screen.
Figure 74 SYSTEM > Interface Setup > Add/Edit
The following table describes the labels in this screen.
Table 30 SYSTEM > Interface Setup > Add/Edit
LABEL
Interface Type
Interface ID
Apply
Clear
Cancel
Chapter 20 Interface Setup
DESCRIPTION
Select the type of IPv6 interface for which you want to configure. The Switch supports the VLAN
interface type for IPv6 at the time of writing.
Specify a unique identification number (from 1 to 4094) for the interface.
To have IPv6 function properly, you should configure a static VLAN with the same ID number in the
SWITCHING > VLAN screens.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
GS1920v2 Series User's Guide
118