MacDon M 2009 Series Assembly Instructions Manual page 77

e. Connect center-link:
HYDRAULIC LINK WITH OPTIONAL
SELF-ALIGNMENT KIT
REEL DOWN
HEADER UP
HEADER
TILT DOWN
HEADER DOWN
1. Adjust position of the center-link cylinder (E)
with the REEL UP an d REEL DOWN
switches, and HEADER TILT switches on the
GSL to po sition the h ook above the h eader
attachment pin.
IMPORTANT
Hook release (J) mu st be down to
enable self-locking mechanism. If the
release is open (up), manually push it
down after hook engages header pin.
Form 169542
UNLOADING AND ASSEMBLY
REEL UP
HEADER TILT UP
J
E
2. Lower the center-link onto the hea der with
REEL DOWN switch until it locks into position
(hook release (J) is down).
3. Check that center-link is locked onto header
by pressing the REEL UP switch on the GSL.
4. Proceed to step f. on next page.
HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT (M155, M105 OPTIONAL)
1. Activate HEADER TILT cylinder switches on
GSL to extend or retract center-link cylinder
(E) so that the hook lines-up with the header
attachment pin.
2. Stop engine, and remove key from ignition.
3. Push down on rod end of link cylinder (E) until
hook engages pin on header, and is locked.
Hook release (J) must be down to enable
self-locking mechanism. If the release i s
open (up), manually push it down after hook
engages header pin.
4. Check that t he center-link is locked onto
header by pulling upward on rod end of
cylinder.
5. Proceed to step f. on next page.
77
J
IMPORTANT
(continued next page)
Revision F