MacDon M 2009 Series Assembly Instructions Manual page 51

C. M105
a. Remove hydraulic oil reservoir filler cap/dipstick.
b. Open engine compartment hood fully.
c. Locate plug on TOP of HEADER d rive pump
housing from above, and l oosen plug to blee d
pump housing. Re-tighten plug once oil starts to
run out.
Form 169542
UNLOADING AND ASSEMBLY
51
d. Locate plug on TOP of T RACTION drive pump
housing from above, and l oosen plug to blee d
pump housing. Re-tighten plug once oil starts to
run out.
e. Replace hydraulic oil reservoir filler cap.
f. Open maintenance platform on LH side.
g. Disconnect brake engage solenoid connector
(P-V3) at valve block on LH side of windrower.
(continued next page)
Revision F