MacDon M 2009 Series Assembly Instructions Manual page 83

f. Connect center-link:
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT
1. Adjust position of the center-link cylinder (E)
with the REEL UP an d REEL DOWN
switches, and HEADER TILT switches on the
GSL to po sition the h ook above the h eader
attachment pin.
IMPORTANT
Hook release (J) must be down to enable
self-locking mechanism. If the release i s
open (up), manually push it down after hook
engages header pin.
2. Push the REEL DOWN switch on the GSL to
lower the center-link onto the header until it
locks into position (release (J) is down).
3. Check that center-link is locked onto header
by pressing the REEL UP switch on the GSL.
4. Proceed to step g. on next page.
Form 169542
UNLOADING AND ASSEMBLY
J
E
J
E
HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT (M155 OPTIONAL)
REEL DOWN
HEADER UP
HEADER
TILT DOWN
1. Activate HEADER TILT cylinder switches on
GSL to extend or retract center-link cylinder
(E) so that the hook lines-up with the header
attachment pin.
2. Stop engine, and remove key from ignition.
3. Push down on rod end of link cylinder (E) until
hook engages pin on header, and is locked.
Hook release (J) must be down to enable
self-locking mechanism. If the release i s
open (up), manually push it down after hook
engages header pin.
4. Check that center-link is locked onto header
by pulling upward on rod end of cylinder.
5. Proceed to step g. on next page.
83
REEL UP
HEADER TILT UP
HEADER DOWN
IMPORTANT
(continued next page)
Revision F