MacDon M 2009 Series Assembly Instructions Manual page 37

C. M105
a. Connect hoses as follows, using colored plastic
cable ties as a guide.
111324 GREEN
1. Locate two hoses 111324 (green tie s) in
frame opening, and existing tee fitting (green
tie) on the hose from the valve block.
2. Remove caps on green lines and tee, and
make connections. Tighten fittings.
NOTE
Remove caps on tee last to minimize oil
loss.
3. Position hoses into frame.
4. Locate two h oses (white ties) in side frame,
and hose 111324 with tee (white tie).
5. Remove caps, make connections, and tighten
fittings.
6. Push hoses into frame.
Form 169542
UNLOADING AND ASSEMBLY
111328 WHITE 'T'
37
RED
7. Locate two hoses (red ties) inside frame.
8. Route RH hose behind bundle.
9. Remove caps, make connection, and tighten
fitting.
10. Push hose into frame.
119328 WHITE
11. Retrieve long hose 11 9328 (white tie), and
route through hole in LH frame.
WHITE
12. Remove caps on hose, and valve block fitting
(white tie), and make connection. Ti ghten
fitting.
(continued next page)
Revision F