Table of Contents
Advertisement
MECHANICAL LINK (M155 OPTIONAL)
WARNING
Stop windrower engine, and remove key
before making adjustments to machine. A
child or even a pet could engage the drive.
1. Stop engine, and remove key from ignition.
J
K
2. Loosen nut (J), and rotate barrel (K), to adjust
length so that other end lines-up with header
bracket.
3. Install clevis pin (L), and secure with cotter
pin.
4. Adjust link to required length for proper
header angle by rotating barrel (K). Tighten
nut (J) ag ainst barrel. A slight tap with a
hammer is sufficient.
Form 169542
UNLOADING AND ASSEMBLY
K
L
CAUTION
Check to be sure all bystanders have cleared
the area.
HEADER DOWN
g. Start engine (if not running), and press HEADER
UP switch to raise header to maximum height.
If one end of the header does not raise
fully, the lift cylinders require re-
phasing. If re-phasing is needed,
proceed as follows:
1. Press and hold HEADER UP switch until both
cylinders stop moving.
2. Continue to hold the switch for 3–4 seconds.
3. Cylinders are phased.
84
HEADER UP
NOTE
(continued next page)
Revision F
Advertisement
Table of Contents
