Table of Contents
Advertisement
h. Bundle traction drive hoses, and secure with two
plastic cable ties at 7-3/4 in ch (200 mm) intervals
from frame opening.
i.
Bundle smaller hoses, and se cure with two
plastic cable ties at 6 inch (150 mm ) intervals
from frame opening.
j.
Attach hose supports to windrower frame a s
follows:
1. Locate hose bundle from valve blocks on LH
side of frame. Route hose ends with electrical
harness through hose support.
Form 169542
UNLOADING AND ASSEMBLY
39
2. Disengage hook, and rotate to up po sition.
Position hose bundle over hose support, and
locate under hook.
re-engage in bracket.
3. Attach reel hose support tube to the RH leg
with two 3/8 in. x 1.0 carriage bolts and nuts.
Rotate hook, and
Revision F
Advertisement
Table of Contents
