MacDon M 2009 Series Assembly Instructions Manual page 79

h. Install pin (N) through each boot and foot, and
secure with hairpin.
IMPORTANT
Ensure pin (N) is fully inserted, and
hairpin is installed behind bracket.
i. Remove lynch pin from pin (O) in stand (P).
j. Hold stand (P), and remove pin (O).
k. Re-position stand to storage position by inverting
stand, and re-locating on bracket as shown
l. Re-insert pin (O), and secure with lynch pin.
Form 169542
UNLOADING AND ASSEMBLY
N
P
O
m. Remove pin (Q) from storage position in linkage,
and insert in hole (R) to engage float springs.
Secure with lynch pin.
n. Disengage lift cylinder stop by turning l ever (L)
downward to raise stop until lever lo cks into
vertical position.
o. Repeat for opposite cylinder
CAUTION
Check to be sure all bystanders have cleared
the area.
REEL DOWN
HEADER UP
HEADER
TILT DOWN
p. Start engine, and activat e HEADER DOWN
switch on GSL to lower header fully.
79
Q
R
L
top.
s
REEL UP
HEADER TILT UP
HEADER DOWN
(continued next page)
Revision F