MacDon M 2009 Series Assembly Instructions Manual page 57

h. Attach two additional wires in the wiring harness
to the radio:
1. Circuit 503: Red with 1/4 in. female blade
terminal. This is a live
powering a radio clock/memory, if these exist
on your radio.
2. Circuit 315: Black ground wire attache s to
radio body.
i. Plug cable from antenna into radio.
An approved radio package is available
from Radio Engineering Industries
(REI) of Omaha, Nebraska.
j. Attach stud (supplied with radio) to center rear of
radio.
k. Attach support (D)
to stud on b ack of
radio chassis, with
lock washer and
metric nut (C) that
was supplied with
the support.
Support can be
attached to chassis
in multiple locations
to allow for proper
mounting of radio.
l. Re-install radio panel with original screws.
J
m. Adjust bracket (J) if necessary by loosening nuts
(K) to allo w radio to slide into ope ning, and
securely capture support (D).
n. Turn ignition key to ACC, switch radio ON, and
check operation in accordance with instructions
supplied with the radio.
Form 169542
UNLOADING AND ASSEMBLY
wire provided for
NOTE
C
D
K
D
57
Revision F