MacDon M 2009 Series Assembly Instructions Manual page 82

CAUTION
Check to be sure all bystanders have cleared
the area.
REEL DOWN
HEADER UP
HEADER
TILT DOWN
HEADER DOWN
b. Start engine, and activat e HEADER DOWN
button on the GSL to fully retract header lift
cylinders.
IMPORTANT
If the center-link is too lo w, it may contact
the header as the windrower approaches
the header for hook-up.
E
c. If necessary, adjust position of the h ydraulic
center-link (E) so that the hook (F) is above the
attachment pin on the header by o ne of the
following 2 methods (shown in next column):
Form 169542
UNLOADING AND ASSEMBLY
REEL UP
HEADER TILT UP
F
82
1. If the optional center-link self-alignment kit is
installed, activate the REEL UP switch on the
GSL to raise the center-link (E).
E
2. Without the self-alignment kit, re-locate the pin
(G) at the fra me linkage as required to raise
the center-link (E).
B
d. Slowly drive windrower forward so that feet (H)
on windrower enter boots (B) on the header.
e. Continue to drive slowly forward until feet engage
the boots, and header nudges forward.
G
H
(continued next page)
Revision F