MacDon M 2009 Series Assembly Instructions Manual page 29

g. Remove five remaining bolts securing caster to
shipping frame. Retain bolts for attaching caster
to walking beam.
CAUTION
Stand clear when lifting, as caster may swing.
h. Lift caster assembly off ship ping frame, and
position at end of walking beam.
i. Insert RH ca ster extension into walking beam,
and position for desired tread.
j. Install six 3/4 in. bolts and hardened washers into
walking beam and caster beam. Use longer bolts
through anti-shimmy bracket.
Form 169542
UNLOADING AND ASSEMBLY
29
k. Tighten bolts as follows:
1. Snug up the two bolts underneath beam.
2. Tighten the four back bolts to 330 ft·lbf
(447 N·m).
3. Tighten bolts underneath beam to 330 ft·lbf
(447 N·m).
l. Repeat above steps g. to k. for LH caster.
m. Re-torque bolts at 5, and 10 hours of operation.
Revision F