MacDon M 2009 Series Assembly Instructions Manual page 35

c. Remove clamp from round plastic hose block.
TRACTION DRIVE - LH
CASE DRAIN
VIEW LOOKING AFT TOWARDS PUMPS
d. Insert four traction drive hoses and one case
drain hose into slots in block as shown, and
re-install clamp.
Form 169542
UNLOADING AND ASSEMBLY
TRACTION DRIVE - RH
e. Connect drive hoses to pump as follows:
SHORT - YELLOW
1. Remove caps, and attach hoses with short
elbows to re spective side of pump (ei ther
yellow or no tie). Tighten fittings.
LONG - NO TIE
2. Remove caps, and atta ch hoses with long
elbows to respective side of pump (either red
or no tie). Tighten fittings.
f. Retrieve the two
(111312) at front frame, and the 7/8 in. tee fitting
on the hose, from the pump.
35
SHORT - NO TIE
LONG - RED
motor case drain hoses
(continued next page)
Revision F