MacDon M 2009 Series Assembly Instructions Manual page 65

h. Install pin (A) through each boot and foot, and
secure with hairpin.
IMPORTANT
Ensure pin (A) is fully inserted, and hairpin
is installed behind bracket.
i. Remove lynch pin from pin (F) in stand (G).
j. Hold stand, and remove pin (J).
k. Reposition stand to storage position by inverting
stand, and re-locating on bracket as shown.
Re-insert pin (F), and secure with lynch pin.
l. Remove pin (H) from storage position in linkage,
and insert in hole (J) to
Secure with lynch pin.
Form 169542
UNLOADING AND ASSEMBLY
A
G
F
H
J
engage float springs.
m. Disengage lift cylinder stops.
n. Start engine, and activate HEADER DOWN switch
on GSL to lo wer header fully. Stop engine, and
remove key.
o. Connect header drive hydraulics (K) and electrical
harness (L) to header.
Header Unloading and Assembly Instructions.
65
L
K
Refer to you r Auger
Revision F