g. Open maintenance platform on LH side.
h. Disconnect brake engage solenoid connector
(P-V3) at valve block on LH side of windrower.
i.
Disconnect electrical connection at fuel pump on
right side of engine.
Form 169542
UNLOADING AND ASSEMBLY
50
j.
Open maintenance platform on RH side (M205,
M155).
k. Open circuit breaker/fuse box, and remove ECM
ignition fuse (5A).
CAUTION
Check to be sure all bystanders have cleared
the area.
l.
To prime the system, crank engine with starter f or
15 seconds.
m. Re-connect electrical connection at fuel pump
and at brake engage solenoid.
n. Re-install ECM ignition fuse, and close fuse box.
o. Close engine compartment hood.
p. Check hydraulic oil l evel in re servoir. Add
SAE15W-40 oil if necessary.
Revision F