Table of Contents
Advertisement
F
e. Remove hairpin on pin s (F), and rem ove pins
from header legs.
CAUTION
Check to be sure all bystanders have cleared
the area.
REEL DOWN
HEADER UP
HEADER
TILT DOWN
HEADER DOWN
f.
Start engine, and activat e HEADER DOWN
button on the GSL to fully retract header lift
cylinders.
IMPORTANT
If the center-link is too lo w, it may contact
the header as the windrower approaches
the header for hook-up.
G
Form 169542
UNLOADING AND ASSEMBLY
REEL UP
HEADER TILT UP
H
71
g. If necessary, adjust position of the h ydraulic
center-link (G) so that the hook (H) is above the
attachment pin on the header by o ne of the
following methods:
1. If the optional center-link self-alignment kit is
installed, activate the REEL UP switch on the
GSL to raise the center-link (G).
G
2. Without the self-alignment kit, re-locate the pin
(J) at the frame linkage as required to raise
the center-link (G).
K
h. Slowly drive windrower forward so that boots (D)
enter header legs (K). Continue to drive slowly
forward until lift linkages contact support plates in
the header legs, and header nudges forward.
i.
Ensure that lift linkages are properly engaged in
header legs, contacting support plates.
J
D
(continued next page)
Revision F
Advertisement
Table of Contents
