MacDon M 2009 Series Assembly Instructions Manual page 31

m. Remove clamp from ro und plastic hose block.
Case drain hose is pre-installed in block.
TRACTION DRIVE - LH
TRACTION DRIVE - RH
VIEW LOOKING FORWARD
n. Insert four traction drive hoses into slots in block
as shown, and reinstall clamp.
Form 169542
UNLOADING AND ASSEMBLY
o. Connect drive hoses to pump as follows:
CASE DRAIN
p. Retrieve the two motor case drain hoses (111312)
q. Remove caps from the hoses only.
31
SHORT - YELLOW
1. Remove caps, and attach hoses with short
elbows to re spective side of pump (ei ther
yellow or no tie). Tighten fittings.
LONG - NO TIE
2. Remove caps, and atta ch hoses with long
elbows to respective side of pump (either red
or no tie). Tighten fittings.
at front fram e, and the 7/ 8 in. tee fitting on the
hose, from the pump.
SHORT - NO TIE
LONG - RED
(continued next page)
Revision F